Wednesday, October 06, 2021

Scratch Built Tower for Sludge


One of the terrain pieces I have been wanting to make for the Sludge project was a tower. Not necessarily a utilitarian piece of terrain, but something to put in the background - I think including verticality to a wargames table adds a lot to the look. I have put off the project on the basis that it was not really a necessity (is anything really a necessity in a hobby?), but the lockdown left me with a little more time than I usually have...

As it so happens I used up this bottle of handwash, and wouldn't you know it the size is just about right.


I cut off the top part of the bottle where the screw threads are, and made a conical roof for the tower with a piece of cardboard. I made a base for the tower with 3mm PVC foam board, which gives it rigidity and is not prone to warping. I glued small rectangles of 1mm PVC foam card along the walls to mark the windows.

I made a gable entrance for the tower using 1mm PVC foam card. The door comes from a CastleCraft kit - it is more 22mm than 28mm, but works well enough. I added a metal ring from a jewellery piece as the door ring.

The finial on the roof is the end of a ballpoint pen (that's to FG for the tip) and the end of a banner pole from the Oathmark Undead kit. I added shingles cut from cardboard to the roofs using double-sided tape, and sealed them with a coat of PVA glue.

I applied a coat of Modge Podge to the tower and base, and when that has dried, I glued sand and gravel to the base.

I sprayed the whole piece with a brown primer, and when that has dried I sprayed a layer of flat white paint in a zenithal fashion, leaving some brown at the bottom of the tower and in the recesses.

I then painted the base brown and dry-brushed it with some grey mixed into the brown, and then applied some weathering powder to the base of the tower. I applied some light wash to the body of the tower to show some streaking.

The joint between the entrance and the wall was rough on one side, so I hid it with some vines.


The finial was painted to look rusted. For the windows I just peeled off the PVC foam card pieces I applied earlier, and painted the space black.

I applied more tufts than I had expected to to hide the bits where there was too much brown paint on the tower.

This was a fun and quick build, not accounting for the drying times. The construction is pretty crude, but I think the door and the finial give it the details that make it look more refined.

5 comments:

Simon Quinton said...

That is pretty neat! Great spot I wish I had an eye for spotting items to use like this. It turned out really well!

pancerni said...

Good looking tower, pleasing to the eye....which is as you pointed out, what matters.

captain arjun said...

Thanks, gents.
Too much time on youtube watching crafters gave me the itch

Ray Rousell said...

That looks pretty cool!

Codsticker said...

Very nicely done. Very natural looking the way you have blended the different materials together.